Beschreibung:- fits ALL Yeti versions
- easy to open hood system
- hood self-holding system
- all brackets, installing hardware are made in Czech Republic (EU)
- easy to install for everyone (2 persons are better for proper install)
- install takes 7-10min (see below)
First prototype tested (20/10/2011):
Install guide:
1) install bottom triangle bracket
PHOTO 1 PHOTO 2 PHOTO 3 PHOTO 4
2) install upper support bracket
(please note the not-painted place position under the hood holder)
PHOTO 1 PHOTO 2
3) install damper using washers and nuts
PHOTO 1 PHOTO 2 PHOTO 3 PHOTO 4 PHOTO 5
4) remove soft dampening foam
PHOTO 1
PLEASE NOTE:
when CLOSING hood, please start pushing the hood with your right hand gainst the upper damper bracket
and then with left hand push it on the grille
PHOTO 1 PHOTO 2 PHOTO 3
when OPENING hood, please hold the hood at the grille position
until the hood is opened completely, to avoid opening hood too fast
PHOTO 1 
%7Cutmcsr%3D(direct)%7Cutmcmd%3D(none)%3B%2B__utmv%3D92407340.noscript){kind=small}